01/10/13 at 7:40 am #26224
Here are a few pics and tutorial for those who have not removed the rear wheel before. I will add putting it back on once I get my tire fixed. I am always really nervous when it comes to doing something for the first time on my bike. It took less than 5 minutes.
I put the bike on the stand. The 06 has a 32mm axle bolt. Loosen and remove the axle nut in the right axle. Remove the washer under the nut. I laid my parts out on a towel so I knew right where they were.
Take a rubber mallet and knock loose the axle from the side. I had to insert a screwdriver on the left side while putting pressure on the tire with a 2×4 to pry the axle far enough to get a hand on it to pull it through
Slide the wheel to the ground and push forward to get slack in the chain. then remove the chain from the sprocket
Now carefully pull the wheel out watching the brake. The bracket slides on the swingarm so as you pull the wheel out and you have clearance move it out of the way.
Be careful and watch for the spacers on each side of the wheel. They may fall out. Mine stayed in place so they were easy to find.
Be careful not to lay the tire down on the sprocket side since it may damage your sprocket. The brake disk sits inside the edge of your tire so lay it on that side and pull the sprocket from the rim. There are 6 rubber spacers under the sprocket. Remove those and set aside.
I didn’t want to see the rust on the outside edge of my bearings so I will need to change those soon. The bearings roll smooth though.
So with all my parts out they needed a good cleaning. Brake cleaner can loosen grease and grime but it evaporates and leaves the grime stuck on. I used Simple Green and a stiff brush. Great degreaser!01/14/13 at 8:10 pm #26373
adminRegistered MemberRideCBR GuruPoints: 127,297
Thanks for the how-to.. i’ll post a blog article about it when it’s done.03/27/13 at 10:58 pm #30590
Updated pics**04/17/14 at 6:49 am #5618104/17/14 at 8:46 pm #56223
94f2-08rrRegistered MemberRideCBR GuruPoints: 18,255
@spdygak – Thanks! Most of the people I know, do not do their own work. They would rather pay someone than learn for themselves. I’ll have to try this for myself.04/18/14 at 8:35 am #56244
i just read through that again and realized I never talked about putting it back on. I will update this weekend.
I paid for my first couple oil changes @94f2-08rr and realized I can’t afford to pay $100 every couple months. I was afraid to touch the fairings and thought it would be difficult but I will tackle anything now. I’ve removed my gas tank and all before. It gets easier/better the more you do. I still need to do a front tire how-to as well.04/18/14 at 11:18 am #56249
You must be logged in to reply to this topic.